How to distinguish the quality of automatic binding machine

1. As the saying goes, it is difficult for a skillful woman to make a meal without rice. When we start to look at the equipment, a poorly equipped equipment can't go anywhere. In many cases, it is because of a small screw or a rough edge. Therefore, on the one hand, it must not be saved. The automatic terminal machine must use a high configuration.

2. The actual effect of wire stripping and cutting should be carefully observed to see whether the cable after stripping by the automatic wire binding machine can not be stripped clean, the stripping mouth is not aligned at both ends, the copper core wire is damaged, the skin is scratched, the cable has obvious bumps and the length is different. In that case, there is a relative deviation between the length of stripping and cutting, which is 0.2 mm (set length × 0.002mm）.

3. The effectiveness of riveting terminals. The quality of an automatic terminal machine depends on its effectiveness of riveting terminals. If the terminals riveted are skewed, or the copper core is not rolled, or the crimping socket is loose, it will immediately damage your product quality. This could be a fatal injury.

4. If the speed of the automatic terminal machine is the same as the above two points, the speed of the automatic terminal machine may be its next important indicator value. In fact, enterprises choose automatic terminal machine or prefer its automation technology. If its speed is higher, it means that it will bring you higher economic benefits. In that case, the standard is that the whole vehicle harness produced and processed by automatic terminal machine is qualified.

5. The equipment has not been available for a long time. The equipment that has just been out for a year or two is likely to have many problems and instability. We cannot pay for their variability.