What are the corresponding solutions if the binding machine fails

The wire binding machine is a new type of equipment. Through strict technical design, we all know that the equipment will be damaged due to some uncertain factors during normal use for the winding and binding of the harness. Fault. Then how to handle the failure. What are the corresponding solutions?
1. Abnormal load is usually caused by using a full binding machine beyond the scope of equipment and privately increasing the winding load caused by bearing damage.
Treatment method of the manufacturer of the binding machine: control the winding load within the allowable value of the equipment, timely replace the damaged bearings, clean the relevant parts, and use clean lubricants.
2. The factory assembly problem usually refers to the failure caused by the failure of the equipment to correctly assemble the bearings during the equipment installation.
Treatment method of wire binding machine manufacturer: check the bearing clearance to determine whether the bearing can be used continuously, clean relevant parts, improve the sealing device to prevent secondary failure caused by foreign matters, and use clean lubricant.
3. The user's maintenance system is not perfect, and the equipment lacks necessary regular maintenance and lubrication. This kind of failure is the main reason for the failure of the binding machine. The bearing temperature rises abnormally, the lubricating oil leaks seriously, and the bearing discolors.
Treatment method: establish a good equipment maintenance system, assign special personnel to regularly maintain the equipment, regularly check the lubricating parts, timely supplement lubricant, select appropriate lubricant, timely adjust the position of the shell shoulder, and remove foreign matters. Something near the bushing.
In addition, the wire binding machine is specially used for wire winding and binding of wire products, so why should there be a binding machine? Let's consider what it would be like if the mass produced harness products were not bundled together. The harnesses are scattered and there is no sorting at all. All kinds of harnesses are tangled together, causing trouble for our use.
Therefore, for the binding effect of the harness??, Automatic winding machine is still required. The use of the binding machine eliminates the need for manual binding, which saves a lot of complex work, saves production time, and improves our work efficiency.