Function and universal adjustment mode of automatic wire binding machin

With the rapid development of scientific and technological progress, the modern automatic wire binding machine integrates electrical control system, gear transmission, optical inspection and many other technical aspects, so the difficulty coefficient of setting and adjusting is also greatly increased. After purchasing the binding machine, many customers can't set it. The paper lists the following aspects of the function and general adjustment mode of the automatic binding machine.

1. Understand the equipment function and the whole process of winding
After purchasing the full-automatic winding machine, you must first power on and run it with full load. The first step is to check whether the winding machine operates stably and whether there is abnormal noise. As a program debugging, you should check whether each function is reasonable one by one according to the winding machine guide during the whole process. This is also the whole process of making you understand the equipment. After understanding the function of the equipment, you should find the relative content according to the whole process of product winding. The function of the equipment is the whole process of checking whether the function of the equipment conforms to the winding regulations. When purchasing the equipment, it is necessary to communicate with the equipment dealer in detail about the function of the equipment to prevent the equipment from being purchased without payment and winding regulations. The allowable transmission line diameter of the equipment, large load, total width and precision of the transmission line are the basic data information to determine whether the equipment and winding resistance regulations are considered.

2. Equipment accessories setting and data information measurement
After the adjustment staff understand the function and main parameters of the equipment, they must also measure the support force adjustment of the winding machine and the data information of the winding module. In general, the larger the cable diameter of the winding application, the greater the tension must be. The adjustment scope of the equipment support force of different manufacturers is different, and the tension required for the application of aluminum and copper core wires is also different, The aluminum wire with the same cable diameter must have a smaller supporting force than the copper core wire. If the supporting force is adjusted for AC, the specific cable diameter around the mold shell will be reduced. If it is a thin wire, it will cause tearing, tying and other conditions. If the supporting force is too small, it will cause electromagnetic coil edema, wire row disorder and other conditions. Therefore, the supporting force adjustment is a very important setting. Different cable diameters are in the category of safety supporting force, The adjustment staff should pay attention to the width and height-width ratio of the bobbin and whether it is matched with the bobbin. If it is too tight, it will endanger the handling of the bobbin, and if it is too loose, it will cause the bobbin to shake and endanger the actual effect of the bobbin.